The Apex 35 combines all mountain strength, enduro stiffness and XC lightness. The front panel that closes at 240 ° is what has allowed us to obtain very high levels of structural rigidity and reliability, while minimizing weight. in different lengths, including the extra short of only 33mm!
Follow the indications and tightening torques indicated in the instructions supplied with the attachments, also listed below.Correct installation of the faceplate
[video width="1080" height="614" m4v="https://www.riecycle.it/wp-content/uploads/fbc-apex-fitting.m4v"][/video]
Apex bindings assembly
What you need: Torque wrench, 4mm hex wrench,
water resistant grease .
Important: Follow the step-by-step procedure
Prepare the fork steerer
- Make sure the steerer has a diameter of 28.6mm (1 1/8 ");
- Cut the steerer following the fork manufacturer's instructions so that there are 3mm between the end of the steerer itself and the top of the stem (Fig. 1);
- Make sure that the outer surface of the steerer and the inner surface of the stem are clean and dry.
Fig 1.
Assembly
- Remove all screws, grease the threads and under the head (not under the washers). If the screws are not greased correctly, the tightening of the attachment on the tube, by tightening the screws according to the prescribed torque of 5Nm, drastically decreases.
- Insert the steerer in the connection and place any shims. Fit the top cap and tighten the top cap screw as directed by the manufacturer.
- Install the fontalini as shown in the video above, sliding them from the outside towards the center of the handlebar (Fig. 2). The word "zero Gap" must be at the bottom, on the outside (Fig. 3).
Fig 2.
Fig 3.
- While pulling the handlebar towards the stem body, insert the screws and tighten the lower part of the faceplate until it touches the stem . (Fig. 4).
Fig 4.
- Insert the two upper screws and tighten them slightly (three / four turns)
- Tighten the screws at the bottom with the 5Nm torque wrench (Fig. 5).
Fig 5.
- Center the handlebar and position it according to your preferences, then tighten the two screws at the top to 5Nm (Fig. 6).
Fig 6.
- Insert the two remaining screws, align the coupling correctly and tighten to 5Nm (Fig. 7).
Fig 7.
- Installation completed :-)